Adding on a 2 axis servo gimbal, checking for wobble and demonstration of gimbal in action. This style frame and gimbal can be
Traxxas Villain EX with dual Marine Titan 550 motors and running 14.4v 7.2v 3000MAH x 2 batteries. This is the first run since
Quick 1st flight of the Syma X8C (DJI Phantom low cost clone) with SJ4000 attached in Union, NJ.
Syma Double Horse 7000 (EP Victory 700) run on the pond, no editing. Windy and rough waters, yet a balmy 50 degrees made for a
Reached 100 subscribers and look forward to the next 100 +! I welcome all comments and will do my best to make sure I reply. As
8AM short flight.
This is a maiden of the DIY DJI Phantom 1.1.1 using the stock GoPro gimbal. Results were not enough anti-vibration to get rid of jello
Day after building comes the maiden flight to see how it reacts to forward movement and overall handling. Not bad, haven't adjusted
Bench-testing motors, ESCs and tail servo movement. Slight crackling noise, not sure if due quality of solder or combination of
Quick overview, thoughts and mods. Places to purchase: http://www.banggood.com/Syma-X8C-Venture-with-2MP-5MP-Wid...
Aerial video footage from back yard. Winds low to ground not so bad, but in the sky, the v222 combated the 8 to 10mph winds (
RC Speed boating with Syma Double Horse 7000, stock SC380 dual motors and 7.2v 1800 mah batteries. Purchased from xheli.
Friday evening 3rd flight of the Dragonfly. Little wobble at times, will increase P and I Gains next time and see how that affects flight.
DJI F450 clone 1st "out of the box" hovering attempt equiped with KK 2.1 HC, EMAX 4in1 25A ESCs, APC 10x4.5 props, and EMAX
Maiden short flight with a few turns and hover.
After using a different anti-vibration dampeners ( $2 part go figure) and using MoonGel ($6 part) with the 2 Axis servo gimbal, the "
First trial run with the new 1/10 ECX AMP MT Brushed RC Truck @ Tripower RC track in Union NJ. Brushless setup to be installed
Out at the Union NJ Recreation field Sunday May 3rd, 2015 testing Quadcopter after crash and re-soldering of power lead joints.
DIY DJI Phantom custom build. Wanted to build one for less cost and achieved that for under $300. Already had Fly Sky FS-TH9X
Loss of power out of nowhere due to faulty QA on Receiver board from factory. Wires for power seem to come loose after a few bad
2015 © All Rights Reserved.